27
Remove the feeding elbow assemblies from each
mix tank by first sliding the connecting tube away
from the pump cover, Then turn the elbow assembly
slightly and pull the assembly straight up and out of
the mix tanks.
Remove the mix pump assemblies from each mix
tank by rotating each pump clockwise until the
hook stud disengages from the rear pump hub.
After disengaging the hook stud, pull the pump
assembly straight forward and out of the mix
storage tanks. Please ensure that the mix pump
drive shaft and seal must also be removed at this
time.
After removing the parts from the mix storage
tanks, fill each mix tank with luke warm (80-90F)
water and a non-foaming dish washing detergent
solution.
Press the Push to Select button on the front touch
pad (#571.2), and carefully select the Beater mode.
Allow the machine to run for 1 – 2 minutes then
push the Stop / Reset button (#571.1) on the touch
pad. Drain all of the water and soap solution from
the machine. Repeat this process until the water
drained is clear.
Prior to draining the last time, brush clean all
surfaces of the mix storage tanks with the cleaning
brushes provided with the freezer.
Drain the remaining water and soap solution from
the freezer.
571.1
571.2
L 1
