Need Help?
Schedule Video Call
Support@coldtribe.com
Filling the Tub
* Ensure your tub is in the ideal location
before starting to fill as you will not be able
to move it once water is inside
1.Use garden hose to fill the water if
accessible OR use garden hose faucet
adaptor to connect to bathroom sink.
2. Begin filling tub while monitoring for any
leaking
3. Once water fills above the min mark you
may begin the next steps of turning on the
chiller.
Chiller Start Sequence and Testing
1. Start by testing the safety shut off plug by
plugging it into a power outlet. A red light
should turn on.
a. Press Test on the plug to test the
shut off - light should turn off
b. Press Reset on the plug to reboot
the power back.
c. Test Weekly
2. Turn on the the power bottom and
monitor the following:
a. Leaks
b. Filter is filling up with water
c. E3 may flash for less than 30
sec.then water should start flowing.
coldture.com
