_____________________________________________________________________________
Cole-Parmer CLW-108i & CLW-128i Washers
24
How to Start a Cycle
1.
Turn the washer ON by pressing
the
ON / OFF POWER
SWITCH
to the ON position
(switch location is illustrated on
page 15). The control panel’s display and indicators then
energize. The control panel is illustrated on page 16.
2.
Select the desired program type by pressing the control
panel’s
PROGRAM SELECTOR BUTTON
until the
desired
PROGRAM INDICATOR LAMP
illuminates.
1
3.
For all program types except RINSE-ONLY, select high or
low temperature operation using the
HIGH-HEAT WASH
SELECTOR BUTTON
. Available wash temperatures are
listed in Table 3-2 on page 6.
4.
If you would like the cycle to start automatically after a
delay of from 1 to 12 hours, press the
START-DELAY
SELECTOR
until the desired interval is displayed.
5.
If a high-heat rinse is desired, press the
HIGH-HEAT RINSE
(HR) SELECTOR BUTTON
until its indicator illuminates.
Available rinse temperatures are listed in Table 3-2 on page 6.
6.
To begin the cycle, push the
START / STOP BUTTON
.
The control panel’s
START INDICATOR LAMP
illumi-
nates and the estimated time remaining decrements on the
DISPLAY WINDOW
.
7.
At the end of the cycle, the control panel’s
START INDICA-
TOR LAMP
extinguishes and the
END
lamp illuminates.
How to Pause or Abort a Cycle
To
pause
cycle operation, insert your hand, palm up, into the
door’s
HANDLE COVER
, pull the latch, wait a few moments
for spray-arm movement to stop, then pull the door slightly open.
To
resume
the cycle from the point at which it paused, re-close
the door so that it is securely latched.
2
1
For help determining which cycle and option-button settings are appropriate for your application, see
Section 3, “Washer Overview,” beginning on page 4.
2
If a power failure occurs while a cycle is running, restoration of power resumes the cycle from the point at
which it paused.
OFF
ON
