Place one of the blades on the hub socket and insert one of the M6-20 socket head cap
screws. Place a plastic disk on the end of the screw and then place a self-locking nut (M6)
and tighten it with the 5mm hex key. Repeat this procedure on all three blades.
C A U T I O N : O V E R - T O R Q U E OF SCREWS CAN D A M A G E T H E B L A D E S AND
W I N D TURBINE
Remove the M16 nut from the rotor shaft. Slide the blades assembly onto the rotor shaft and
place the nut on the shaft. DO NOT press the rotor shaft into the body.
Insert the 8mm hex key into the rotor shaft and thread the nut by spinning the blade
assembly. Hold the blade assembly and tighten the M16 nut lightly with the 8mm hex key.
Finally, spin the blades slowly to be sure they turn freely.
Summary of Contents for 011-2044-8
