STITCH LINE
• Remove guylines , canopy poles and pegs. (Fig. 18, 17, 16, 15, 12,
11, 2 and 1)
• Remove rainfly from tent. (Fig. 13)
• Lower the frame one leg pole at a time by pushing the lock
buttons and collapsing the telescoping leg poles. (Fig. 7)
• Fold the arm joints located at each of the tent corners. (Fig. 6)
• Hold roof pole and press button on joint to unlock the roof joint.
• Lift roof joint, lower arms and fold arms towards center.
• Place the tent in the carry case for storage.
TIP:
After collapsing the tent, place it on its side, then roll it
multiple times with pressure to reduce its size. This will allow the
unit to slip into the carry case.
Guy Out the Tent
• Attach and peg out guylines.
HINT:
During setup, keep doors zipped to keep proper tension
on fabric.
TIP:
Tent walls can be converted into canopies with closures.
Unzip the vertical gussets on tent walls, extend the tent walls
and insert the tips of canopy poles into the grommets on
the bottom edge of tent walls (canopy).
The canopy can be
converted to an awning when canopy poles are removed.
(Fig. 17 and 18)
Fig. 13
Fig. 14
5
Attach Rainfly
• Drape rainfly over tent. Secure rainfly with straps located on
the underside of rainfly. (Fig. 13 and 14)
• Connect the elastic loops (found at the rainfly corners) to
the pegs at four corners. (Fig. 15)
• Stake down the other elastic loops at the bottom of the
rainfly to the ground. (Fig. 16)
Fig. 15
Fig. 16
Fig. 17
6
Canopy
Pole
Grommet
Fig. 18
Pole
Strap
Elastic
Loop
Disassembly
To take down the tent, follow the previous steps and
illustrations in the reverse order:
7
To take down:
Hold roof poles and press
button on joint to unlock.
1. Remove rainfly, spread out on floor of tent, then unzip door
& vents before taking tent down for storage.
2. Neatly fold tent to width of carry case, roll tightly, and
place in carry case.
3. All pegs must be placed in the storage bag to prevent
damage to the fabric items placed in the carry case.
4. Make sure all components are clean and dry before
placing in carry case.
5. Store in a clean, dry area.
8
To Store
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet
clothing inside the tent. It is NOT LEAKAGE through the tent fabric.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping
off tree limbs can cause damage to the tent fabric and its coating
resulting in leaks or loss of flame-resistant properties.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack pegs inside
your tent. Use a separate storage bag.
• Pegs should be removed by pulling on the peg itself. NEVER
PULL ON THE TENT TO REMOVE PEGS AS THIS COULD RESULT IN
PROPERTY DAMAGE OR PERSONAL INJURY.
• Do not leave your tent set-up for weeks at a time. Be aware that
exposure to ultraviolet rays from the sun can seriously damage
material and/or cause it to become discolored.
• This product is not intended to be used during heavy rain, wind,
hail, snow or other inclement weather. Excess water build-up
can cause the frame system to become unstable, and possibly
collapse, causing injury.
• The tent should be taken down and placed in storage during
windy conditions to avoid damage to product or personal injury.
• DO NOT use gas or flame sources under or near this product.
This tent meets the flammability
requirements of CPAI-84. The fabric
may burn if left in continuous
contact with any flame source.
The application of any foreign
substance to the tent fabric
may render the flame-resistant
properties ineffective.
WARNING: KEEP ALL FLAME
AND HEAT SOURCES AWAY FROM
THIS TENT FABRIC.
Coleman Brands Pty. Ltd.
Unit 5-6, 13 Lord Street,
Botany NSW 2019
Australia
Telephone: 1800 224 350
Email: customerservice@colemanaust.com.au
www.colemanaustralia.com.au
© 2017 The Coleman Company, Inc.
All rights reserved.
Coleman
®
,
, and
are
registered trademarks of
The Coleman Company, Inc.
4010052723 (ECN20060939-02)
