4
To repair or replace reflector, refer to Figure 1.
Remove four hex-head screws holding reflector to burner head using a 11/32" wrench (Figure 1).
Also see Note #1.
To repair or replace burner screen, refer to Figures 1-5. To avoid cuts, do not run fingers or
hands along edges of thin sheet-metal parts.
Remove reflector (Figure 1). Remove 4 lower hex-head screws holding burner screen to burner
screen assembly bottom using a 7/16" wrench (Figure 2). Lift burner screen assembly top from
heater head (Figure 3). Also see Note #1. Remove 4 upper hex-head screws holding burner screen
to burner screen assembly top using a 7/16" wrench (Figure 4). Finally, remove burner screen
assembly top (Figure 5). Reassembly caution: Edge of screen with holes closer to the edge goes
“up” on re-assembly (attached to screen assembly top). When reinstalling burner screen make
sure that the oval hole at the bottom edge of the burner screen (Figure 3-a) is lined up with the
hole in the burner screen bottom, marked Pilot Port (Figure 3-b).
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Caution:
After completion of repairs and before operating the patio heater, make
sure you read and follow all safety information in the Instructions for Use manual. If
you do not have this manual, contact Coleman at 1-800-835-3278 or TDD 316-832-8707.
Figure 3-a
Figure 3-b
Oval Hole
Burner Screen
Burner Screen
Bottom
Model 5040 A Repair Manual
