English - 4
■
Close cover. (Fig. 9 and Fig. 10)
■
Attach chain as shown.
(Fig. 11 and Fig. 12)
To Light
SERVICE SAFETY
•
Keep all connections and fittings
clean. Inspect propane cylinder and
lantern propane connections for
damage before attaching.
•
During set up, check all connections
and fittings for leaks using soapy
water. Bubbles indicate a leak. Never
use a flame.
CAUTION
If you smell gas:
1. Do not attempt to light appliance.
2. Extinguish any open flame.
3. Disconnect from fuel supply.
4. Call 1-800-835-3278.
WARNING
•
Replace any mantle with a hole in it.
A hole can cause lantern to overheat
and create a hazard. Never operate
lantern without heat shield.
WARNING
BURN HAZARD
•
Never leave lantern unattended when
hot or in use.
•
Keep out of reach of children.
WARNING
EXPLOSION - FIRE HAZARD
•
Propane is heavier than air and
can accumulate in low places.
If you smell gas, leave the area
immediately.
•
Always attach or detach propane
source outdoors; never while lantern
is lighted, near flame, pilot lights,
other ignition sources or while
lantern is hot to touch.
•
Always light & use lantern outdoors.
•
This lantern must not be exposed to
flammable vapors or liquids
during lighting.
•
This lantern is very hot during use
and can ignite flammables too close
to the mantles. Keep flammables at
least 12 inches from the sides and
48 inches from the top of the lantern.
Keep gasoline and other flammable
liquids and vapors well away
from lantern.
DANGER
■
Make sure mantle is properly
positioned with top and bottom in
grooves of burner. (Fig. 4)
■
Ignite mantle. (Fig. 5 and Fig. 6)
■
After mantle has burned, install globe
and seat globe in position.
(Fig. 7 and Fig. 8)
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 11
Fig. 12
Fig. 9
Fig. 10
■
Install mantle. Make sure small hole
is at top and larger hole is at bottom.
Colored part is up. (Fig. 3)
