2
3
PRINTED IN SRI LANKA
Rev. 11/04
Things You Should Know
•
Never store shelter, even for a short period of time, without drying it thoroughly and
brushing off caked dirt. Do not pack stakes or poles inside your shelter. Use
separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER
PULL ON THE SHELTER FABRIC OR STAKE LOOP TO REMOVE STAKE.
•
SHELTER POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
•
Do not leave your shelter set-up for weeks at a time, be aware that exposure to the
ultraviolet rays of the sun can seriously damage material and/or cause it to become
discolored.
WARNING: Keep all flame and heat sources away from this shelter fabric
.
This shelter meets the flammability requirements of CPAI-84. The fabric will burn if
left in continuous contact with any flame source. The application of any foreign
substance to the shelter fabric may render the flame-resistant properties ineffective.
THE COLEMAN CO., INC
.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
Attach Shelter to Frame
– With the frame still partially set up,
clip the center of the Screen House
to the center hub. (illus. 3)
– Starting towards the center of the
Screen House, clip the shelter fabric
to the poles.
Complete Shelter
– Fully extend each pole by straightening
all shock-corded pole sections.
– Insert the pin on the pin and ring
system, at the corner of the Screen
House into the the pole end.
(illus. 4), (illus. 6)
– Repeat for remaining poles.
– Adjust poles to pull the shelter
taut and stake down through
the fabric loops at the end of
pin and ring. (illus. 5), (illus. 6)
– Attach guy lines to fabric
guy loops at each corner
and stake out. (illus. 6)
illus. 3
Screen House clipped to
partially assembled frame
Start by attaching the
center of the Screen
House to the pole hub.
illus. 4
Insert into the
pole end
illus. 6
Completed shelter
with guy lines
staked out
illus. 5
Stake through
stake loop
