Assemble Frame
– Insert one end of the Main Tent Pole tips into
the grommet on the same webbing located at
the corner of the tent. (illus. 3), (illus. 4)
– Go to opposite end of the Main Tent Poles and
gradually apply pressure to the poles, forming
an arch, until you are able to insert the pole tips
into the grommet. This is easiest if you insert
them in the same order back to front. (illus. 4)
– Insert end of Cross Pole into grommet at the
corner of tent and go to opposite end
of the Cross Pole and gradually apply
pressure to the pole, forming an arch,
until you are able to insert the pole
tips into the grommet. (illus. 4)
ascend
™
2
part number 9840-230
1
2
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with doors facing
desired direction. (illus. 1) Unzip doors.
– For best results in windy conditions, position
door or back of tent into the wind.
– Stake down tent corners. Keep the floor
taut. (illus. 2)
– Assemble Frame Poles by interlocking the
shock-corded sections. This will make two
long red tipped Main Tent Poles and one long
silver Cross Pole.
– Insert the two Main tent Poles through the pole
sleeves with the red trim.
– Insert the silver Cross Pole through the pole
sleeve with the silver trim.
Main Tent Poles (Red Tip)
Part No. 9840-101
Cross Pole (Silver)
Part No. 9840-102
Rainfly
Part No. 9840-110
illus. 1
illus. 2
Tent stake
through Loop
illus. 3
Insert Pole Tip on
stake loop into pole.
illus. 4
Tent frame up
POLE ASSEMBLY PARTS
Main Tent Poles
Cross Pole
