To Set Up
cont.
To Light
7
■
Remove plastic cap from top of
propane cylinder and screw
propane cylinder into REGULATOR
hand tight.
CAUTION
• SERVICE SAFETY
Keep all connections and fittings
clean. Inspect propane cylinder
and stove propane connections for
damage before attaching.
During set up, check all connec-
tions and fittings for leaks using
soapy water. Bubbles indicate a
leak. Never use a flame.
Attach propane cylinder
■
Make sure burner valve is
turned to off position.
■
Check the connection between
the cylinder and the regulator with
soapy water. Bubbles indicate a
leak. Never use a flame. Check that
the connection is not cross-thread-
ed and that it is tight. Perform
another leak check. If there is still a
leak, remove the cylinder and con-
tact Coleman for service or repairs.
Leak Check
■
Make 2-3 oz. of leak check solu-
tion (one part liquid dishwashing
detergent and three parts water).
DANGER
• EXPLOSION - FIRE HAZARD
• Propane is heavier than air and can accumulate in low places. If you smell
gas, leave the area immediately.
• Always attach or detach propane source outdoors; never while stove is lighted,
near flame, pilot lights, other ignition sources or while stove is hot to touch.
• This stove is red hot during use and can ignite flammables too close to the
burners. Keep flammables at least 12 inches from the sides and 48 inches from
the top of the stove. Keep gasoline and other flammable liquids and vapors well
away from stove.
■
Set on sturdy, flat area.
For outdoor use only
.
■
Insert lighted match through hole
in GRILLING SURFACE and open
BURNER VALVE.
■
Adjust flame with BURNER
VALVE.
■
Flame should be blue with hint of
yellow on tips.
A
