Español-10
Lista de piezas
Encendido estándar
No.
428
Descripción
1
220C1401
Tapa de combustible
2
220A6201
Juego de reparación de la bomba
3
414-6601
Válvula y generador
4
414-5621
Generador
5
413D3461
Quemador auxiliar
6
R413-149T
Perilla de la válvula
7
425A3451
Quemador principal
8
426A5281
Conjunto del colector
9
426-3141
Rejilla
10
414-5601
Ensamblaje del Tanque
11
639-1091
Taza de bomba y presilla
12
413B4971
Presillas de los de
fl
ectores de viento
13
N/A
Conjunto de encendido
14
N/A
Perilla de encendido
15
200-6381
Ensamblaje de válvula de retención y tubo
VEA EL DETALLE “A”
VEA EL DETALLE “A”
English-4
■
Place tank on level surface resting at
angle shown. (Fig. 2)
Leak Check
Fig. 2
■
Remove FUEL CAP. Use a funnel or
suitable
fi
lling device and
fi
ll with
clean, fresh fuel.
■
Replace FUEL CAP on tank and
on fuel container. Tighten
fi
rmly.
WIPE UP ANY SPILLED FUEL AND
DISPOSE OF IN A SAFE PLACE.
Fig. 3
Pumping
■
Be sure FUEL VALVE is OFF
(Fig. 4) and FUEL CAP is
fi
rmly
closed (Fig. 5).
Fig. 4
Fig. 5
■
Place thumb over hole in pump knob
and pump approximately 30 full
strokes. (Fig. 7)
■
Close PUMP KNOB. (Fig. 8)
Fig. 7
Fig. 8
■
Make sure FUEL VALVE is fully
“OFF”.
■
CHECK FOR LEAKS in one or more
ways. Look for fuel mist or a wet
appearance of fuel on surfaces.
Listen for hiss of escaping gas. Smell
for fuel odor. Never use a
fl
ame. Do
not use if leaking. (Fig. 9)
■
Open PUMP KNOB one full turn.
(Fig. 6)
Fig. 6
Fig. 9
CHECK
FOR
LEAKS
CHECK
FOR
LEAKS
CHECK
FOR
LEAKS