STITCH LINE
To Attach Rainfly
(continued)
3.
Insert end of each black Rainfly Pole into pin on either side of
front door. (Fig. 10 & 10A)
4.
Go to opposite end of Rainfly Pole and gradually apply pres
sure to form an arch. Insert the pin into pole end at other side
of the door. (Fig. 10 & 10A)
5.
Locate
all
hook & loop fasteners on underside of Rainfly and
wrap around black and grey poles to secure. (Fig. 10B)
6.
Stretch elastic straps and hook clip on each to the metal loops
at the front and back of the tent. (Fig. 10C)
7.
Extend out vestibule flaps and secure with metal stakes
through the loops in the web straps (Fig. 10 & 5D)
8.
Stretch guylines until taut, then secure with stakes.
(Fig. 10 & 10E)
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA • PRINTED IN CHINA
© 2008 The Coleman Company, Inc.
Coleman
®
, , and are registered trademarks and Legacy
TM
is a trademark of
The Coleman Company, Inc.
4010004158 (20081029))
Things You Should Know:
•
Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your tent. Condensation is caused by water
vapor from your breath, perspiration, or any wet clothing inside the tent.
It is NOT LEAKAGE through the tent fabric. It can be minimized by
removing wet clothing from your tent and by providing good ventila-
tion through the tent.
•
Tree limbs, tree sap, bird droppings, or moisture steadily dripping off
tree limbs can cause damage to the tent fabric and its coating resulting
in leaks or loss of flame-resistant properties.
•
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
•
Stakes should be removed by pulling on the stake itself. NEVER PULL ON
THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
•
Tent poles should not be left telescoped together during storage.
•
Do not leave your tent set-up for weeks at a time. Be aware that exposure
to ultraviolet rays from the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
Cooler Access
The smaller zippered opening at the side of
tent is designed for added ventilation and easy
access to your beverage cooler.
1.
To use as a vent, unzip flap to expose
screen.
2.
To use as a cooler access, unzip other flap to make an avenue
to bring beverages into tent. (Fig. 17)
To Store
1.
All poles and stakes
must
be placed in the storage bag to pre
vent damage to the fabric items placed in the carry case.
2.
Make sure tent is clean and dry before placing in carry case.
3.
Remove rainfly, spread out on floor of tent, then unzip door &
vents before taking tent down for storage.
4.
Neatly fold tent to width of pole storage bag, place on tent, roll
tightly, and place in carry case.
5.
Store in a clean, dry area.
Electrical Cord Access
1.
Unzip the access panel in the
lower left corner of tent and bring
in an electrical cord.
NOTE:
Use only UL approved cords
rated for outdoor usage. (Fig. 16)
Fig. 17
Fig. 16
Fig. 10
10A
10B
10C
10E
10D
Guylines
