Periodic Maintenance and Adjustment 8-14
1. Torque wrench
Tightening torque:
Oil filter cartridge:
17 Nm (1.7m·kgf, 12ft·lbf)
7. Install the engine oil drain bolt, and then
tighten it to the specified torque.
8. Add the specified amount of recommended
engine oil, and then install the engine oil
filler cap and tighten it.
CAUTION:
In order to prevent clutch slippage (since the
engine oil also lubricates the clutch), do not
mix any chemical additives. Do not use oils
with a diesel specification of
“
CD
”
or oils of
a higher quality than specified. In addition, do
not use oils labeled
“
ENERGY
CONSERVING II
”
or higher.
Make sure that no foreign material enters the
crankcase.
9. Start the engine and warm it up for several
minutes. While warming up, check for oil
leakage. If oil leakage is found, turn the
engine off immediately and check for the cause.
10. Turn the engine off, and then check the
Summary of Contents for POWERSPORTS HS360ATV
