3Dsupport@utec.com.mo
DIY Heat Bed Installation
4. Plug the Heat Bed wire to the power supply and power on, the
heat bed will start to heat up.
3. Fix the heat bed and glass to the DIY platform using the metal
clip, then remove the handle of the metal clip ;
Setup target heating temperature
by adjust the regulator:
1. Press “SET”,
2. Press “DEC-” or “INC+” to
input the target heating
temperature; (60 or 65
℃
for
PLA, 85 or 90
℃
for ABS)
3. After input, press “SET” to
confirm;
4. Bed will be heat up to the
target temperature.
SET DEC-
INC+
The actual bed temperature will show
in the Display of the regulator.
