Error sequence
The
Error sequence
function is used to indicate the sequence of errors, occurred since
calling up this function. The last 21 errors are indicated at the most. The type of error is
listed in the Technical Appendix
'Error messages'.
The display only indicates the error
number.
The cause of a labelling error and a labeller failure can mostly be determined thanks to
the error history. The following figure shows an example of such an indication:
ERROR LOGFILE
9, 0,14,14, 9, 9, 0
5, 7, 9, 9, 2, 8, 3
0,11,12, 9, 3, 8, 9
Self-test
The
Self-tes
t function is used to test the electronics of monitor and drive. The Self-test
makes an own menu available.
The
'SELF-TEST'
menu tree indications are as follows:
SELFTEST
Test RAM
Test EEPROM
Test Keyboard
Test LED
Test LCD
Test Backlight
Test I/O Controller
Test I/O Monitor
Test Drive
Test RAM
The
Test RAM
function is used to test the RAMs of the monitor. A detected RAM error
is indicated as follows.
TEST RAM
Test ok
programmer/operator
RUN/STOP
User level:
Operating mode:
programmer
STOP
User level:
Operating mode:
5999.530-01B 13.08.98 WM
Page 33 /
49