Technical specifications
24
3.2.1 Options
Side labeling set
(optional)
The optional „Lying Down Set“ will be used for installation where the product has to
be labeled on the side.
The optional „Side labeling set“ is made up of:
Rewinder disc Ø150mm
Unwinder dancer ring
Pressure bearing for unwinder core
Stabilization set for unwinder
Pressure roller
open sensor
(optional)
(TUO = Traction Unit Open) – Checks the position of the pressure roller located on
the traction roller. If the pressure roller has been lifted (manually or by paper jam) the
labeler will stop immediately (and the ERR-output will be set).
Paper break
Sensor
(optional)
Magnetic flap
adapter (MFA)
(optional)
CP21 Wrap around
unit (optional)
CP21-BUDGET
(optional)
(OOL = Out Of Label) – The paper break can (optionally) be configured to act as
paper break sensor. This sensor checks the paper path. In case of empty paper roll
(OOL = Out Of Label) or in case of a paper break (no paper/label between paper
brake spring and paper break axle) the labeler will stop immediately (and the ERR-
output will be set).
Labeling of light products or labeling into hollow products. The adapter will be
controlled with the FEED signal. The pressing down time extension can be adjusted
(potentiometer DELAY) on the adapter board GS070D.
The optional wrap around unit CP21 will be used, if we have to wrap a label around a
round body. A magnetic flap adapter will be used (MFA) to do this job. The extension
of the wrap around time is adjustable (see MFA).
Similar function like CP21 (see above) – but without magnetic flap adapter function.
The pressure to the dispensing edge will be controlled by a simple hand lever –
activated and hold down by the user.
