6.5 Nonstop mode
The
Nonstop mode
function allows continuous labelling with two labellers. The dispensers are
connected together and exchange signals. There is a difference between the two dispensers. The
first labeller in feed direction is the
MASTER
labeller and controls the second labeller called
SLA-
VE
labeller. When selecting the nonstop mode the labeller has to be defined as
MASTER
or
SLA-
VE
with
up
or
down
key:
NONSTOPMODE
Function : MASTER
Now to the
Error handling
in a nonstop-configuration:
a
WARNING
at one of the two labelers will normally activate a
switch-over
from the faulty acti-
ve labeler to the passive labeler. The supervision of the correct switching time is always mana-
ged by the Master. The controlsignal relais output
NOK
of the faulty active labeler will switch to
ON
a
ERROR
at one of the two labelers will normally activate a
switch-over
from the faulty active
labeler to the passive labeler. The supervision of the correct switching time is always managed
by the Master. The faulty labeler will stop (red LED on) immediately. The controlsignals
ER-
ROR
and
NOK
will switch to
ON
If the master-labeler runs into problems (
ERROR
), the slave-labeler is still able to complete the
remaining job
If the slave-labeler has a problem (
ERROR
), the conveyor has to be stopped, because pro-
ducts between the master and the slave will stay clear (no label on it)! - except while using the
dot-command to switch from slave to master (enforce mastercontrol). The controlsignals
ER-
ROR
and
NOK
will switch to
ON
to indicate the corresponding ERROR- and NOK-conditions
programmer
STOP
User level:
Operating mode:
5999.530-01F 07.04.2006 WM
35
Summary of Contents for Etiprint Inline
