Collomix GmbH
DYNAX
450
Version 1.7-18
17
8.
Cleaning, maintenance, and service
It is necessary to check, clean, and service the machine regularly to ensure continuous function.
Unplug the machine from power by pulling the plug before all cleaning, maintenance, and repair
work is done on the machine.
8.1
Cleaning
Remove any spilled mixed compound immediately from the interior of the machine. For this
purpose use a rag or a scraper. Be careful not to damage any connections or sensors.
After cleaning the splash guard, apply a thin film of spray oil in order to avoid any sticking of color
splashes.
Soiled threaded spindles can be cleaned with a rag or a wire brush. The threaded spindles must be
re-lubricated with
MOLYKOTE® BR 2 plus
after cleaning.
CAUTION
Damage to the machine through dry run ball bearings
If you clean the machine with a high-pressure washer, the lubricant is washed out from the ball
bearings and they run try.
•
Never clean the machine with a high-pressure washer or similar.
•
Replace dry-run ball bearings immediately.
8.2
Maintenance
Every week:
•
Remove any dirt from the machine.
•
Apply a thin coat of lubricating oil at the two guide columns (1).
Every 6 months:
•
Check the PERMA lubricating cartridge (2) and replace it if necessary.
•
Lubricate the threaded spindle (4) and the spindle shaft with MOLYKOTE® BR 2 plus.
•
Check that the lock pin of the mixing unit moves smoothly.
•
Check the tension of the V-belt. Replace the V-belt if it is worn or damaged.
•
Check that the locking lever (5) moves smoothly and lubricate lightly with grease.
•
Check that the bottom clamping table and the slide (3) moves smoothly. Remove any dirt.
•
Check that all ball bearings move smoothly. Ball bearings are to be found on the two clamping
jaws, on the drive shaft at the transmission gear and on the clamping tables.
•
Check that the door lock is in good working good.
8.3
Service
If service is required, please consult the customer service or the manufacturer of the machine.
DANGER
Danger of death by dangerous voltage
Do not open the housing or remove any safety equipment of the machine. Please note that all
maintenance and servicing jobs must be left strictly to authorized and suitably trained expert
staff. The proper state of all safety equipment and electrical equipment is to verify and
document after the repair.
Only use original spare parts.
Do not modify or change safety-related parts!
Any additional components added may not impair safety and must be approved by the
manufacturer.
1 Guide columns
2 PERMA cartridge
3 Slide pull out mechanism
4 threaded spindle
5 Locking lever
1
2
3
4
5
