Collomix Rühr- und Mischgeräte Gmbh
Shaker
V
IBA
15
&
V
IBA
25
D-85080 Gaimersheim
Edition
2.3-05
13
5.7
Triggering the Emergency Stop function
Press the
Emergency Stop button
to switch off the machine if ever the container
develops a leak or its handle becomes loose or some other potentially dangerous
situation for man or machine arises while the mixing cycle is in progress.
After the machine is switched off, the mixing unit will coast to a standstill and remain in
this position.
The Emergency Stop button
has to be unlocked again by hand
. This is done by
turning the red actuator clockwise.
After unlocking the Emergency Stop button you must cancel the message in the display
by pressing
button E
.
Both the mixing unit and the door interlock are automatically released. You can then
remove the container.
CAUTION!
The Emergency Stop button only interrupts the program flow. The machine is not
disconnected from the mains supply!
Therefore, before performing any maintenance work or repairs be sure to
always disconnect the machine from the mains by pulling out the power plug!
5.8
Average mixing cycles
The VIBA Shaker has three mixing cycles whose lengths can be individually programmed
by a service technician.
The length of a mixing cycle depends on the properties of the material to be mixed. The
times quoted in the following table are intended to serve as a guide only. Depending on
the actual material it may be necessary to select a longer mixing cycle in order to obtain
optimal results.
Material to be mixed
Mixing time
House paints, industrial paints
- 60 seconds
Dispersion paints
60 - 150 seconds
Ready-mixed plasters
150 - 240 seconds
E 020 Emergency stop
> unlock switch
•
•
Ready
1:00 2:00 3:00
LCD display:
EMERGENCY STOP
