Collomix Rühr- und Mischgeräte Gmbh
Shaker
V
IBA
15
&
V
IBA
25
D-85080 Gaimersheim
Edition
2.3-05
31
9.3
Error messages
The following table provides an overview of possible errors and their remedies. Please note that all maintenance and
servicing jobs must be left strictly to authorized and suitably trained personnel. This applies in particular to those jobs
printed on a
gray
background which have to be performed with the housing open.
Fault
Machine status
Remedial actions
E000 stand-by mode
•
If 60 minutes pass without the user
actuating any function, the machine
will go into stand-by mode
•
Press button E to cancel stand-by mode
E010 door open
•
The door is open
•
Close the door
•
The door is closed and the LED for
24V is off
•
Check the fuse for 24 V
•
Check the 24 V circuit
•
Check the transformer
•
The door is closed and the LED for
24V is on
•
Check the door interlock system
•
Check the lead/connector to the door interlock
E020 emergency stop
•
The EMERGENCY STOP button has
been pressed
•
Release the EMERGENCY STOP button
•
The EMERGENCY STOP button has
not been pressed
•
Check the switching element of the EMERGENCY STOP button
•
Check the lead/connector to the EMERGENCY STOP button
E025 door not locked
•
The door has been unlocked by hand
•
Lock the door by hand
•
The door has not been unlocked by
hand
•
Check the door interlock system
•
Check the lead/connector to the door interlock
E040 max. open
•
The mixing unit is fully open
•
Note that the maximum container height is 400mm
•
The mixing unit is not fully open
•
Check whether the threaded spindles move smoothly, clean
and lubricate with grease as necessary
•
The container is too unstable
E050 defective pot
•
The container is defective
•
Check the clamping pressure
•
The container is not defective
•
Check whether the clamping plate moves smoothly
•
Check the clamping plate proximity switch
•
Check the lead/connector to the clamping plate proximity
switch
E130 door switch fault
The machine does not start
•
Check the door interlock system
•
Check the lead/connector to the door interlock
E140 only high clamp*
The machine clamps with only high
clamping pressure
•
Check the rotation sensor
•
Check the distance from the sensor to the rotary pulse
encoder
•
Check the lead/connector to the clamp motor
E150 clamp motor fault
The machine does not clamp
•
Check the clamp motor
•
Check the lead/connector to the clamp motor
E150 clamp belt fault
The machine does not clamp
•
Check the clamp belt
*only VIBA 25
