14
13
Pixel 8
0-255
Pixel 8 saturation control (0-100%)
15
14
Pixel Macro
0-015
No function
016-035
Macro 1 from slow to fast
036-055
Macro 2 from slow to fast
056-075
Macro 3 from slow to fast
076-095
Macro 4 from slow to fast
096-115
Macro 5 from slow to fast
116-135
Macro 6 from slow to fast
136-155
Macro 7 from slow to fast
156-175
Macro 8 from slow to fast
176-195
Macro 9 from slow to fast
196-215
Macro 10 from slow to fast
216-235
Macro 11 from slow to fast
236-255
Macro 12 from slow to fast
2.
2.
2.
2. S
S
S
Safety
afety
afety
afety IIIInstructions
nstructions
nstructions
nstructions
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
If the device has been exposed to temperature changes due to environmental changes, do not switch
it on immediately. The arising condensation could damage the device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be earthed.
The electric connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case,
replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
During initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective, it should decrease gradually.
Please don't project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances, keep more than 50cm distance with wall for
smooth air flow, so there should be no shelter for fans and ventilation for heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
