Regardless of the rigging option you choose for your LINEAR BEAM PIXEL, always be sure to secure your
fixture with a safety cable. The fixture provides a built-in rigging point for a safety cable on the hanging
bracket as illustrated above. Be sure to only use the designated rigging point for the safety cable and never
secure a safety cable to a carrying handle.
5.
5.
5.
5. DMX-512
DMX-512
DMX-512
DMX-512 control
control
control
control connections
connections
connections
connections
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the
male 3-pin XLR input of the moving head. You can chain multiple
Moving head together through serial linking. The cable needed should be two core, screened cable with
XLR input and output connectors. Please refer to the diagram below.
DMX-512 connection with DMX terminator
For installations where the DMX cable has to run a long distance or is in an electrically noisy
environment, such as in a discotheque, it is recommended to use a DMX terminator. This helps in
preventing corruption of the digital control signal by electrical noise. The DMX terminator is simply an
XLR plug with a 120 Ω resistor connected between pins 2 and 3,which is then plugged into the output
XLR socket of the last fixture in the chain. Please see illustrations below.
1
1
1
1
2
2
2
2
3
3
3
3
PIN 3
PIN 3
PIN 3
PIN 3
PIN 2
PIN 2
PIN 2
PIN 2
120
120
120
120
Ω
6.
6.
6.
6. Menu
Menu
Menu
Menu Operations
Operations
Operations
Operations
MODE
ADDR
VALU
A001~AXXX
(AXXX)
DMX address setting
SLAV
ON/OFF
(SLAV)
Set to slave
AUTO
IP1~8
ALON
(AU-A)
Running built-in program alone
MAST
(AU-M)
Set to master (Auto running)
SOUN
IP1~8
ALON
(SO-A)
Set to sound control alone
MAST
(SO-M)
Set to master (Sound control)
SET
MIC
M-XX
Mic sensitivity
LODA
ON/OFF
Reload data
VER
V-1.0~V-9.9
Software version
DMX
MOD1
15 DMX channel mode
MOD2
14 DMX channel mode
REST
ON/OFF
All reset
