Colortrac Scanner Operator Manual.
8
4 OPERATION OF SCANNER
4.1 Initial start-up
On power up the amber light will flash for approximately 15 seconds. After this the green
light and also the internal scanner lights will turn on. The scanner is now ready for use. On
initial installation Colortrac Ltd recommends that the scanner has its cameras stitch aligned
(except 3640e) and it is colour calibrated / white normalised. For details on how to do this
see section 6 in this document.
4.2 Auto Document Feed
With the green light on, the automatic document feed system allows documents to be
loaded with the leading edge of the document automatically positioned for the start of a
scan. The document should be placed on the paper tray face down either centre justified or
justified along the guide on the right hand side. Push the document towards the scanner lid
making sure it is square to the scanner. The document will then be detected by the
scanner and automatically loaded.
WARNING:
Care should be taken when using the Auto Document Feed to load original documents as
fragile, damaged or tightly-rolled documents may be damaged during loading or
subsequent scanning. If problems are experienced the feed mechanism can be instantly
halted by depressing either the forward or reverse button on the control panel.
COLORTRAC LTD CAN ACCEPT NO LIABILITY FOR DAMAGE TO ANY DOCUMENT
DURING THE LOADING OR SCANNING PROCESS.
4.3 Start Scanning
The host software initiates the scan. Please refer to the software manual for further
information.
WARNING: DOCUMENTS THAT ARE SENSITIVE TO LIGHT SHOULD NOT BE LEFT IN
THE SCANNER. COLORTRAC LTD ACCEPTS NO LIABILITY FOR DAMAGE TO ANY
DOCUMENT DAMAGED BY LIGHT.