5100 SureTrans Versa Instructions
Revised: 7.05
C5100-00-00
3-4
7.
Attach the seat back to the seat bottom
with two 9/16” bolts, which may be pre-
attached to the back frame.
8.
Attach the seat arms to the seat back using the enclosed bolt and internal spacer.
9.
Insert the guide rail clips into the guide rail slots and slide the
seat assembly onto the commode base. If you need to change
the way the chair faces, you may remove the rolling base,
rotate it 180° and insert the guide rail clips into the guide rail
slots, and slide the seat assembly onto the commode base
10.
Slide the foot rests onto the foot
rest clamps.
Operating the SureTrans Versa Transfer System
1.
Set the commode chair to the desired height by depressing the leg tube
locking buttons and sliding the leg tubes in or out. Adjust the shower
base with the leg adjusting buttons so it is the same height as the
commode chair.
2.
Place the shower base in the tub or shower. Level the base with the
leveling feet. The shower base should be the same height as the
commode chair. Lock the leveling feet in place with the jam nuts.
