4.8 TREADLE
– Figure 4.8.1
To remove:
Follow the steps for rear wheel hub removal in
Section 4.7.
Disconnect the speed control arm (A) from the
front of the treadle.
Disconnect the treadle to brake linkage from the
treadle.
Remove the two spindle mounting screws from
each of the treadle mounts (B).
Remove the treadle and treadle mounts.
To install:
Install the two screws through the treadle mounts
into the spindles. Torque both screws to 150 inch
pounds. Tighten the lower mounting screws
securely with an open end wrench.
Connect the treadle to the brake linkage to the
treadle.
Connect the speed control arm to the treadle.
4.9 SPINDLE
To remove:
Follow the steps for rear wheel hub removal in Section 4.7 for both spindles. On the drive wheel side
spindle follow the procedures outlined in the brake installation Section 4.2.
Remove the two spindle mounting screws from each of the treadle mounts (Figure 4.8.1 B).
Remove the lower mounting screws from each of the spindle(s) and remove the spindle(s).
To install:
Install the lower mounting screws into the spindles. Do not tighten.
Install two screws through the treadle mounts into the spindles. Torque screws to 150 inch pounds.
Tighten the lower mounting screws securely with an open end wrench.
On the drive wheel side spindle follow the procedures outlined in the brake installation Section 4.2.
4.10 CHARGER– Figure 4.10.1
To remove:
Disconnect batteries, negative cable first.
Remove the charger cover plate.
Disconnect the DC output leads from the motor
(A) and solenoid (B).
Disconnect the wires from the keyswitch (C) and
battery state of charge meter which is located
under the keyswitch.
Remove the remaining mounting screws from the
charger,
Remove the charger from the vehicle.
NOTICE: Placing a block between the vehicle
sides to spread them slightly will ease in
removal and installation of the charger.
A
B
Figure 4.8.1
4-6
C
A
B
Figure 4.10.1
Summary of Contents for CR-10 Chariot
Page 1: ......
