11
S
ection
3 — A
SSembly
& S
et
-U
p
1.
On the side of the mower, lift the side mulching plug. See
Figure 3-9.
2.
Slide two hooks of side discharge chute under hinge pin on
mulching plug assembly. Lower the mulching plug. Do not
remove side mulching plug at any time, even when you are
not mulching.
Adjustments
Cutting Height
The cutting height adjustment lever is located above the rear left
wheel.
1.
Depress height adjustment lever towards wheel.
2.
Slide lever to desired position for a change in cutting
height. See Fig. 3-10 and Fig. 3-10A.
3.
Release lever towards deck and place lever on one of the six
height adjustment teeth.
b. Slip plastic channel of grass bag over hooks on the
frame. See Fig. 3-7.
2.
Follow steps below to attach grass catcher:
a. Lift rear discharge door.
b. Place grass catcher into the slots in the handle
brackets as shown in Fig. 3-8. Let go of discharge
door so that it rests on the grass catcher.
To remove grass catcher, lift rear discharge door on the mower.
Lift grass catcher up and off of the slots in the handle brackets.
Release rear discharge door to allow it to close rear opening of
mower.
Side Discharge Chute (If equipped)
Your mower is shipped as a mulcher. To convert to side discharge,
make sure grass catcher is off of the unit and rear discharge door
is closed.
Low Wheel
1
2
3
Lower
Higher
Figure 3-9
Figure 3-7
A
B
B
2
1
Side Mulching
Plug
Figure 3-10
Figure 3-8
Summary of Contents for D SERIES
Page 24: ...24 Notes ...
