Page 2 of 2
DISPLAY SETTINGS:
1.
Press the arrow up PB till the “Display” option is highlighted and press the enter
key. This will take you to the
Display
option screen.
2.
Press the arrow down PB till the “Screen Saver” option is highlighted and press
the enter key.
3.
Press the PB labeled “Advanced Settings [F2]”.
4.
Press the PB labeled “Screen Saver Image [F1]”. You need to make sure the
Screen Saver Image is “
DISABLED
”.
5.
Press the PB labeled “OK [F7]. This will return you to the
Screen Saver
screen.
6.
Press the PB labeled “Screen Saver [F1]” to adjust the time base to
30 minutes
.
7.
Press the PB labeled “OK [F7]. This will return you to the
Display
screen.
8.
Press the arrow down PB till the “Cursor” option is highlighted and press the
enter key. This will take you to the
Touch Screen Cursor
screen.
9.
Press the PB labeled “Enable Cursor [F1]”. You need to make sure the Enable
Cursor is “
NO
”.
10.
Press the PB labeled “OK [F7]. This will return you to the
Display
screen.
11.
Press the PB labeled “Close [F8]”.
12.
Press the PB labeled “Close [F8]”.
13.
Press the PB labeled “Reset [F8]” followed by pressing the PB labeled “Yes [F7]
when it asks if you wish to reset the terminal.
When the PV+ unit reboots, it is ready to load the application.
