19
4
Operating
Your Lawn
Tractor
WARNING
Plan your mowing
pattern to avoid
discharge of materi-
als toward roads,
sidewalks, bystanders
and the like. Also,
avoid discharging
material against a
wall or obstruction
which may cause
discharged material to
ricochet back toward
the operator.
Mowing
WARNING: To help avoid blade
contact or a thrown object
injury, keep bystanders, helpers,
children and pets at least 75
feet from the machine while it
is in operation. Stop machine if
anyone enters the area.
The following information will be helpful when using the
cutting deck with your tractor:
WARNING: Plan your mowing
pattern to avoid discharge of
materials toward roads, side-
walks, bystanders and the like.
Also, avoid discharging material
against a wall or obstruction
which may cause discharged
material to ricochet back toward
the operator.
• Do not mow at high ground speed, especially if a
mulch kit or grass collector is installed.
• For best results it is recommended that the first two
laps be cut with the discharge thrown towards the
center. After the first two laps, reverse the direction to
throw the discharge to the outside for the balance of
cutting. This will give a better appearance to the lawn.
• Do not cut the grass too short. Short grass invites
weed growth and yellows quickly in dry weather.
• Mowing should always be done with the engine at full
throttle.
• Under heavier conditions it may be necessary to go
back over the cut area a second time to get a clean
cut.
• Do NOT attempt to mow heavy brush and weeds and
extremely tall grass. Your tractor is designed to mow
lawns, NOT clear brush.
• Keep the blades sharp and replace the blades when
worn. Refer to
Cutting Blades in the Maintaining
Your Lawn Tractor section of this manual for proper
blade sharpening instructions.
Headlights
• On some models, the lamps are ON whenever the
tractor’s engine is running. On other models, the
lamps are ON whenever the ignition key is moved out
of the STOP position.
• On all models, the lamps turn OFF when the ignition
key is moved to the STOP position.
