23
EN
FR
D
IT
PT
ES
Never connect cylinders with pressure greater than 4.5 bar, to avoid damaging the unit.
Use food grade CO² (carbon dioxide) cylinders only.
CAUTION
CAUTION
Connect the external cylinder to a pressure reducer that can be set to a maximum pressure of 4.5 bar. Then
connect the external C02 cylinder to the fitting on the back, using a tube with a diameter of 4 mm.
4. INSERTING AND REPLACING THE FILTER
The filter should be replaced when the number of li-
tres equal to the stated capacity has been dispensed,
when the stated maximum time of use has passed or
when a reduction in the flow of cold or filtered water
is noticed.
Remove the drip tray. Remove the front panel from the
front. Place a cloth under the filter to prevent dripping
from damaging the surface on which the appliance
is placed.
To remove the filter, turn it in a clockwise direction.
Check that the packaging of the new filter is intact:
this is a guarantee of the hygiene of the filter itself. Remove the packaging from the new filter. Before inserting
it, make sure the seals are present and in good condition.
To insert the filter, push upwards into position and turn in an anti-clockwise direction. Do not use any lubricant
to facilitate insertion.
Drain a few litres of water after inserting the filter before drinking.
Note the date of the installation on the filter using a permanent marker.
Summary of Contents for soda TOP CS 18
