32
Treadmill Hardware Manual 1011-0002 v1.02
Using the 7/16in wrench supplied with the treadmill, tighten and loosen the nuts as follows:
•
If the belt is right of center: tighten the nut on the right and loosen the nut on the left.
•
If the belt is left of center: tighten the nut on the left and loosen the nut on the right.
Make small adjustments to the nuts, only ¼ turns, and allow 1 minute for the belt to settle to the new tracking
position. Once the tracking adjustments are complete, follow the belt tensions procedure below.
5.2 Treadmill Belt Tension
If the mechanical sounds of the treadmill appear to have increased in volume, or the belt cannot be stopped
with a heavy downward pressure, then the overall tension of the belt may be too high.
Check the overall belt tension as follows:
•
Set the TREADMILL BELT toggle switch to STOP.
•
Lift the edge of the treadmill surface. The belt should not be less than 4cm (1.5in) from the treadmill
surface. If required, loosen both nuts equally until the height of the belt is 4cm.
5.3 Cleaning
For safety, switch off and unplug all the equipment. Remove the cover with lid and all of lane dividers. All the
parts can be cleaned with a mild soap solution. Do not immerse the treadmill. Try to prevent liquids from
entering the components as this may damage bearings or the electronics inside.
Modular Treadmill
6
–
System Overview
The Columbus Instruments Modular Treadmill is an economical treadmill that can be controlled via computer
interface or manually. It is designed as a stand‐alone system capable of exercising one to four subjects
simultaneously. The basic system consists of three separate units: the Treadmill Controller, the motor
assembly, and the treadmill running lane. Up to three additional lanes can be coupled to the treadmill running
lane to expand the system without adding another controller or motor.
Summary of the features:
•
Can exercise up to 4 subjects simultaneously
•
-10
°
-25
°
of inclination in 5
°
steps
•
Treadmill belt speed adjustable from 1.5 to 102.3 meters/minute
•
Acceleration is adjustable from 0.0 to 25.5 meters/minute/second
•
Automatically timed exercise sessions up to 4:15:59s in 1s steps
•
Automatic distance limited exercise sessions up to 9,999.0 meters in 1.0-meter steps.
•
Optional automatic treadmill belt speed and odometer distance calibration using the calibration wand.
•
Optional Electrical Stimulus, up to 2.34 mA, 200ms pulse, 1, 2, or 3 times per second
•
Optional Air-Puff Stimulus, up to 40PSI, 200ms pulse, 1, 2, or 3 times per second
6.1 System Specifications
Maximum Speed:
99.9 meter/minute
Summary of Contents for Exer 3/6
Page 2: ......
