Page
11 of 15
MANUAL_ACS-230-50W Rev. M02.15
In normal condition following message will be displayed
NOTE:
Prior to turning the front panel power switch ON, p
lease ensure that the RF
output of the RF signal source connected to the Amplifier input is turned off
or below -45
dBm. When the front panel power switch is turned ON, the ACS-230-50W performs a
“
self test”
. ACS-230-50W does not allow the presence of an input signal greater than -45
dBm during the self test and the presence of an input signal will automatically disable
the output and display the following message until RF input is reduced below -45 dBm.
