15
WORK
EMPTYING THE DEBRIS HOPPER
When the machine begins to leave behind clear traces of dirt, this means the hopper
is full and needs emptying.
ATTENTION
: before emptying the debris hopper, close the
hatch by means of the lever on the side instrument panel, and
check there is nobody within the machine's working radius.
To raise the debris hopper, proceed as follows:
1. close the hatch by pushing the lever (1) upwards
2. push up the lever that raises the debris hopper (2) until the required height is reached
3. move next to a debris hopper
4. push the hatch lever (1) down, so the hatch opens to empty the hopper
ATTENTION
: when the debris hopper is raised, move the
machine very slowly - maximum speed 1km/h.
Only empty the hopper when the machine is on an even surface.
Do not activate the filter shaker when the hopper is raised.
After emptying, pull the hatch lever down to close the hatch.
For safety reasons, the hopper lowering operation is only possible if the green
button (1) on the front instrument panel is pressed (with the right hand) at the same
time as the hopper lowering lever (2) is pushed down.
After bringing the hopper back to the working position, open the hatch again by
pushing the lever (3) upwards.
AT THE END OF THE WORK
1. Activate the filter shaker.
2. Empty the debris hopper.
3. Stop the machine.
4. Engage the parking brake.
5. Switch off the machine, brining the key to the OFF position.
2
1
1
3
2
