32
DAILY MAINTENANCE
WARNING: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector of the machine.
WARNING: This operation must be carried out using gloves to protect against
contact with dangerous solutions.
You are advised to invert the right and left-hand brushes every day. If the brushes are not new however,
and have deformed bristles, it is better to reassemble them in the same position (the right-hand one on
the right, and the left-hand one on the left), to prevent the different inclination of the bristles producing
an overload on the brush motor as well as excessive vibrations.
54. DISASSEMBLY OF CYLINDRICAL BRUSHES (S VERSIONS)
1.
Turn the key to the ON/I position.
2.
Turn the I-DRIVE selector to the “Transfer” position. The base will lift if not already lifted.
3.
Turn the key to the “OFF/0” position and remove it from the electrical board.
WARNING: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector of the machine.
WARNING: This operation must be carried out using gloves to protect against
contact with dangerous solutions.
4.
With the base in the high position, release the casing preassembly hinges stop on the right of the
base
5.
Disconnect the right base casing from its location in the body of the base
6.
Remove the brushes from the tunnel, clean with a water jet and replace them. Check the bristles
are not worn; in the event of excessive wear, replace the brushes (the bristles should be at least
10mm long)
7.
Clean the side rubber splash guards of the base
8.
reassemble all the elements.
55. CLEANING DEBRIS HOPPER (S VERSIONS)
1.
Turn the key to the ON/I position.
2.
Turn the I-DRIVE selector to the “Transfer” position. The base will lift if not already lifted.
3.
Turn the key to the “OFF/0” position and remove it from the electrical board.
