18
WORK
22. PREPARING TO WORK
1.
Make sure the dirty water recovery tank is empty; if necessary, empty it completely
2.
Check the main machine switch is set to “OFF”
3.
Check the brush is correctly inserted
4.
Connect the battery connector cable (1) to the main machine connector cable (2) (battery-operated
versions)
5.
Connect the extension cable to the electric system cable, then connect the extension cable to the
mains socket (electric version)
6.
Press the main switch to “ON”. Immediately, on the instrument panel, the display will turn on
indicating the charge level of the batteries.
7.
Adjust the amount of detergent solution by means of the lever (3) on the back of the machine.
8.
Lower the squeegee by releasing lever (4) from its seat.
9.
Activate the suction motor via the relevant switch (5) on the command panel in the rear part of the
machine.
10.
At this point, by using the dead man's lever (6) that activates the brushes, the machine can work
efficiently until the detergent solution runs out or the batteries run flat.
When the battery charge level is almost fully run down, a flashing red light will appear on the display and
the brush motor will switch off automatically, but a residual charge will still allow you to complete the
drying operation. The batteries must be recharged as soon as possible.
23. OVERFLOW
DEVICE
The machine is NOT equipped with an overflow device, because the capacity of the dirty water recovery
tank is greater than the capacity of the solution tank. In particular cases, there is a mechanical device
(float) on the rear wall of the recovery tank; when the dirty water level is too high, this device shuts off the
air to the suction motor in order to protect it - in this case, the noise made by the suction motor will be
deeper. Turn off the suction motor via the switch (1). Then empty the dirty water recovery tank by means
of the special drainage tube. It is good practice, when restoring the level of the solution tank, to empty the
dirty water recovery tank via the special drainage tube.
24. FORWARD
MOVEMENTS
The traction of these machines is obtained by means of the brush which, working with the right weight
distribution, is able to drag the machine forwards.
WARNING: when making even brief reverse movements, verify that the
squeegee is raised.
1
2
3
4
5
6
1
