13
13
WORK
PREPARING TO WORK
1. Connect the connector (1) to the batteries.
1
2. Turn the key of the main switch (only on BT machines) to position “1” (clockwise)
3. Press the brush switch (2)
4. press the suction switch (3)
3
2
5. By means of the tap lever (4), regulate the quantity of detergent solution - it must be
sufficient to wet the floor evenly, but not so much that it leaks from the splash
guard. Remember, however, that the correct quantity of solution always depends
on the type of floor, the degree of dirtiness and the speed used.
6. Release the pedal to lower the base.
7. Lower the squeegee by means of the lever (5)
5
4
8. Via the "man present" lever (6), the brushes begin to rotate and the squeegee
begins to suck in.
9. During the first metres, check there is sufficient solution and that the squeegee
dries perfectly.
6
Summary of Contents for SCRUB 45D
Page 23: ......
