12
MACHINE PREPARATION
8.
CONNECTION OF THE ELECTRICAL POWER SUPPLY CONNECTOR (FOR VERSIONS B-
BT ONLY)
Proceed as follows to connect the machine connector to the battery connector:
1.
Engage the parking brake.
2.
Check that the machine's master switch is in the "0" position.
3.
Lower the base by means of the pedal on the back of the machine
4.
Lower the squeegee by means of the lever on the back of the machine.
5.
Check the recovery tank is empty, otherwise empty it (see the appropriate chapter).
6.
release the hinges (1) on the handlebars
7.
Rotate the tank as far as it will go, using the side handle (2)
8.
Make sure the main switch is disconnected (the key must be set to "0 ").
2
1
9.
Connect the machine connector (1) to the battery connector (2)
10.
Close the recovery tank, always using the side handle to avoid crushing hands.
11.
Close the hinge located on the handlebars, lift the base and the squeegee.
ATTENTION: this is done only once for machines with built-in battery charger,
with the exception of maintenance operations
9.
RECHARGING THE BATTERIES WITH BUILT-IN BATTERY CHARGER (VERSIONS WITH
BC)
The machine is shipped with the battery connector (if supplied) disconnected, connect the battery
connector to the machine connector (see previous paragraph).
To charge the gel battery proceed as follows:
1.
Engage the parking brake.
2.
Check that the machine's master switch is in the "0" position.
3.
Lift the battery charger socket guard (1) on the back of the machine.
4.
Plug the battery charger cable into the electrical system of the machine.
5.
Plug the power supply cable of the charger into the mains socket.
To charge the lead acid batteries proceed as follows:
1.
Engage the parking brake.
2.
Check that the machine's master switch is in the "0" position.
3.
Lower the base by means of the pedal on the back of the machine
4.
Lower the squeegee by means of the lever on the back of the machine.
5.
Check the recovery tank is empty, otherwise empty it (see the appropriate chapter).
6.
release the hinges (1) on the handlebars
7.
Rotate the tank as far as it will go, using the side handle (2)
8.
Lift the battery charger socket guard (3) on the back of the machine.
9.
Plug the battery charger cable into the electrical system of the machine.
10.
Plug the power supply cable of the charger into the mains socket.
When replacing the battery, be sure to use batteries suitable for the battery charger installed.
ATTENTION: the machine is equipped with an automatic system that
disconnects the power supply from the electrical system while the batteries are
being recharged
1
2
1
3
