ADJUSTMENTS
AND
INSPECTIONS
SIMPLA 50 BS
Doc. 10001246
Emitted 07/2006
Rev. 00
Pag.
1 di 4
REPLACE AND DELETE THE DOCUMENT RC2301 REV 01 OF 10/2005 ISSUED 06/2003-MZ
READ THE USE AND MAINTENANCE HANDBOOK
Inspection of the electrical layout
1.
Check the functions of the electrical layout: switches, motors,
solenoid valve.
2.
Check the
control functions and the coupling and uncoupling of the
brushes
.
3.
Control the operation of the chopper
(Machine with traction).
4.
If necessary adjust the chopper-card as
follows:
•
Lift the machine (Traction wheels without
contact to the floor)
•
Open the handlebar unscrewing the four
underlying screws
•
Fix the clamps of the tester (V-DC) to the
connections
M+
and
M-
of the chopper-
card
•
Switch on the main key
•
Insert the forward gear until the 1
°
Microswitch snaps (first speed)
•
The tester should indicate 9-10V. If
necessary adjust the
trimmer “I”
(first
speed), so that the above mentioned
voltage is obtained
•
Activate the forward gear completely, so
that the 2
°
microswitch snaps. The
tester must indicate 24V (max. battery);
Otherwise control the voltage of the
battery and control the cables.
•
Acceleration adjustment: Set the
trimmer “L”
(ACC), so that its position is
turned clockwise about 30°/45° to the
central position. With this adjustment you
obtain the desired voltage (9-10V or
24V) in about 4 seconds.
•
Check the function reverse gear
•
Check motor braking (after release of
the handle bar the machine should stop
in about 1 meter).
