14
AT THE END OF THE WORK
At the end of the work, and before carrying out any type of maintenance:
1. Turn off the tap by means of the lever (1)
2. Raise the base by means of the lever (2)
3. Raise the squeegee by means of the lever (3)
1
3
4. Press the solenoid valve switch (4)
5. Turn off the brush switch (6).
6. Turn off the suction motor switch (5).
7. Bring the machine to the place provided for draining the water
8. Disconnect the plug from the power supply.
9. Engage the parking brake
6
5
4
10. Pull out the pipe on the front of the recovery tank
11. Remove the drainage cap and empty the tank
ATTENTION!
this operation must be carried out using gloves to
protect against contact with dangerous solutions disassemble the
brush and clean it with a jet of water (to disassemble the brush,
see “DISASSEMBLING THE BRUSH” below)
