8
GENERAL RULES OF SECURITY
The rules below have to be followed carefully in order to avoid damages to the operator and to the machine.
Read the labels carefully on the machine. Do not cover them for any reason and replace them immediately if damaged
The machine must be used exclusively by authorized staff that has been instructed for its use
During the working of the machine, pay attention to other people and especially to the children
Do not mix different detergents, avoiding harmful odours
Do not place any liquid containers onto the machine
The storage temperature has to be between - 25
°
C and + 55
°
C
The perfect operating temperature should be between 0
°
C and 40
°
C
The humidity should be between 30 and 95 %
Do not use the machine in explosive atmosphere
Do not use the machine as a means of transport
Do not use acid solutions which could damage the machine
Avoid working with the brushes when the machine stands still, in order to prevent floor damages
Do not vacuum inflammable liquids
In case of fire, use a powder extinguisher. Do not use water
Do not strike shelvings or scaffoldings, where there is danger of falling objects
Adapt the utilization speed to the adhesion conditions
Do not exceed over the limit gradient stated, to avoid conditions of instability
When the machine is in parking position, take off the key and insert the parking brake
The machine has to carry out simultaneously the operations of washing and drying. Different operations have to be carried out in areas which are
not permitted for the passage of non employed staff. Signal the areas of moist floors with suitable signs
If the machine does not work properly, check by conducting simple maintenance procedures. Otherwise, it is better to ask for COMAC technical
service.
Where parts are required, ask for ORIGINAL spare parts to an agent and/or to an authorized dealer.
In case of danger act immediately upon the emergency lever (connector placed on the left side of the operator)
For any maintenance operation take off the power supply from the machine
Do not take off the pieces which require the use of tools to be removed
Do not wash the machine with direct water jets or with high water pressure nor with corrosive material
Every 200 working hours have a machine check through a Comac service department
The machine should not be abandoned, because of the presence of toxic-harmful materials (batteries, oil etc.). This disposal must be subject to
the rules which provide for its scrapping in appropriate centres
The machine does not cause any harmful vibrations
