12
MACHINE PREPARATION
8.
SQUEEGEE
The squeegee, which is packed separately from the machine, should be assembled as shown in the
figure, couple the stud bolts (1 - C85B) or the nuts (C100B) of the squeegee into their seats on the
squeegee support and fix them with a key CH17.
Fit the suction hose (2) into its coupling and fix it with the appropriate clamp
Fit the suction hose (2) into its coupling and fix it with the appropriate clamp
During working operation, the rear rubber has to work slightly tilted backwards and this equally in its
whole length for about 5 mm.
If it is necessary to increase the rubber bending in the central part, then tilt the squeegee body
backwards, loosen the adjuster nut (1) and rotate the knob (2) counter clockwise. If the rubber
bending is to be noticeable at the sides of the squeegee, loosen the adjuster nut (1) and rotate the
knob (2) clockwise. After regulations have been done fix the adjuster nut.
9.
ADJUSTMENT HEIGHT SQUEEGEE SUPPORT
The squeegee has to be regulated in height depending on the wearing of the rubbers. To adjust this:
1.
Loosen the ring nut (1)
2.
With a key CH17 rotate the castor wheel through the nut (2) clockwise to lift the squeegee and
counteclockwise to lower it
3.
Fix the ring nut (1)
NOTE:
The right and left castor wheels have to be regulated equally.
1
2
3
1
1
2
1
