16
• The machine must only be powered with a voltage equal to that
shown on the serial number plate. (B versions).
• If the machine is left unattended, it must be protected from any
accidental movements.
•
The machine must be regularly inspected by a qualified person,
especially with regards the LPG tank and its connections, as
required by local or national safety regulations.
•
When replacing the LPG cylinder, stay far from flames, cinders
or active electric devices. Before replacing it, make sure the
taps of both the old and the new cylinders are turned off (G bi-
fuel versions).
• The seal between the tap and the regulator must be changed
every time the cylinder is changed (G bi-fuel versions).
• After replacing the cylinder, carry out a seal test on the
connections using soapy water (never use flames for this
purpose). After this, perform a machine switch-on test (G bi-
fuel versions).
• If you smell gas, turn off the supply (cylinder tap); air the room
well, bearing in mind that LPG is heavier than air and spreads
at ground level. Have the system checked by specialised
personnel (G bi-fuel versions).
• After every use, turn off the cylinder valve tap (G bi-fuel
versions).
• Non-connected cylinders - whether full, partially full, empty or
presumed empty - must never be kept on the user's premises
(G bi-fuel versions).
• The refuelling place must be well aired. Never refuel the engine
inside a building where the gasoline fumes could come into
contact with flames or sparks.
• Do not refuel when the engine is still hot.
• You are advised to always put on protective gloves before
Summary of Contents for ULTRA 120 B-G
