35
MACHINE
PREP
ARA
TION
FILLING THE GASOLINE TANK (G VERSIONS)
To fill the gasoline tank, proceed as follows:
1. Bring the machine to the refuelling area.
ATTENTION:
the refuelling place must be well aired. Never
refuel the engine inside a building where the gasoline fumes
could come into contact with flames or sparks.
ATTENTION:
do not refuel when the engine is still hot.
2. Make sure the machine is in a safe condition (read “
”).
3. Grip the handle (1) at the side of the seat (
Fig.1
), and raise the
seat mounting plate to the maintenance position (
Fig.2
).
4. Make sure the fuel tap (2) is closed. If it isn't, move the lever (3)
in the direction shown by the arrow (
Fig.3
).
5. Grip the handle (1) and lower the seat mounting plate to the
working position (
Fig.4
).
6. Remove the tank cap (5), rotating it in the direction shown by the
arrows (
Fig.5
).
7.
Make sure the filter (6) of the fuel tank is correctly positioned
(
Fig.6
).
8. Perform the refuelling operation.
ATTENTION:
you are advised to always put on protective
gloves before handling the fuel, to avoid any risk of serious
injury to your hands.
ATTENTION:
for the characteristics of the recommended fuel,
refer to the Use and Maintenance Manual of the endothermic
engine.
ATTENTION:
gasoline is highly and easily flammable. Keep
away from fires and do not shake fuel containers. Don't smoke
in the refuelling area! Discharge any static electricity from
your body before approaching the fuel tank.
ATTENTION:
carry out refuelling operations in well-aired
places only.
ATTENTION:
before refuelling, always switch off the engine.
ATTENTION:
always open the tank cap carefully, to slowly
discharge the overpressure and prevent fuel from spurting
out.
ATTENTION:
don't inhale the fuel vapours.
ATTENTION:
fuels may contain substances similar to
solvents. Avoid any contact of mineral oil products with the
skin and eyes. Use gloves when refuelling. Change your
protective clothes frequently, and clean them.
ATTENTION:
make sure fuel doesn't seep into the ground
(environmental protection).
ATTENTION:
in the event of a fuel leakage, clean the
machine immediately.
ATTENTION:
in the event of a fire, use a powder extinguisher.
Do not use water.
ATTENTION:
to check the level of fuel in the tank, use the
indicator (7) on the right-hand side (
Fig.7
).
9. After refuelling, replace the tank cap.
ATTENTION:
always tighten the tank cap firmly, but without
using tools. The cap must not come loose while the machine
is being used.
ATTENTION:
check the tank for any leaks or ineffective seals.
If you notice a fuel leakage, do not switch on or use the
machine.
ATTENTION:
keep the fuel in containers that meet the legal
requisites and bear an identification label.
3
4
1
2
2
4
7
1
3
5
6
2
4
1
1
3
2
3
Summary of Contents for ULTRA 120 B-G
