19
MACHINE PREPARATION
48.
Rear lights
9. MACHINE'S FRONT COMPONENTS
The front components of the machine are identified as follows:
49.
Headlights
10. TYPE OF BATTERY
To power the machine it is necessary to use:
liquidelectrolyte lead traction batteries;
sealed traction batteries with gas recombination or gel technology.
OTHER TYPES MUST NOT BE USED.
The batteries must meet the requirements laid out in the norms: CEI EN 60254-1:2005-12 (CEI 21-5) + CEI
EN 60254-2:2008-06 (CEI 21-7).
For a good operating performance, we suggest the use of two 18V 480 Ah battery cases.
11.
TYPE OF STARTER BATTERY
As a starter battery, you are advised to use a 12V/35 Ah C5 battery.
OTHER TYPES MUST NOT BE USED.
The battery must meet the requisites indicated in standards CEI EN 50342, CEI EN 60095-2 and CEI EN
60095-4.
12. BATTERY MAINTENANCE AND DISPOSAL
For maintenance and recharging, comply with the instructions provided by the battery manufacturer.
Particular attention must be paid when choosing the battery charger, if not supplied, since there are
different kinds according to the type and capacity of the battery.
When the battery reaches the end of its working life, it must be disconnected by expert, trained personnel,
then lifted (using the grips and suitable lifting devices) to remove it from the battery compartment. DEAD
BATTERIES ARE CLASSIFIED AS DANGEROUS WASTE AND MUST BE DELIVERED TO THE
AUTHORISED BODIES FOR CORRECT DISPOSAL.
WARNING: You are advised to always wear protective gloves, to avoid the risk
of serious injury to your hands.
WARNING: You are advised to only lift and move the batteries with lifting and
transportation means suitable for the specific weight and size.
48
49
