23
MACHINE PREPARATION
3.
Lift the handle (3) to access the motor compartment
4.
Raise the seat mounting plate by turning it as far as it will go
5.
With regard to the safe filling of the combustion engine fuel tank, you must scrupulously observe the
indications given in the motor use and maintenance manual (supplied with the machine)
WARNING: The machine does not have a fuel level indicator, so you must
always check the level before using it.
WARNING: Gasoline is highly inflammable and may explode.
WARNING: Top up the fuel in a well-ventilated area, with the motor switched
off. Do not smoke or take any unprotected flames or sparks near the motor
while it is being filled, or in the area where the gasoline is stored.
WARNING: During the filling operation, be careful not to spill the fuel. Spilt fuel
or fuel vapours could ignite. If any fuel is accidentally spilt, remove it thoroughly
before switching on the motor.
20.
CONNECTING THE LPG CYLINDER (COMBUSTION ENGINE VERSION)
The machine is supplied without an LPG cylinder. To connect the cylinder to the machine, proceed as
follows:
1.
Engage the parking brake (1)
2.
Check the main machine switch (2) is in the “0” position. If this is not the case, turn the key by a
quarter rotation to the right
3.
Position the cylinder as shown in the figure. If it is in the right place, the tap (3) will be on the left side of
the machine
4.
Fix the cylinder to its support by means of the straps (4). To do this, hook the spring (5) to the screw
(6) on the support
WARNING: Use only cylinders measuring 300x600 (max Ø x height in
millimetres) and weighing no more than 23kg.
3
1
2
3
4
5
6
