25
MACHINE PREPARATION
To engage the parking brake pull the lever (4) located near the seat, the red warning light (3) on the
instrument panel will come on.
24.
WORKING FORWARD SPEED
This machine is equipped with electronic traction control. To move the machine, after turning the ignition
key to "ON - I", you must select the direction of movement by operating the switch (1) located on the
instrument panel.
To set the machine in motion, simply depress the accelerator pedal (2); the machine speed is controlled by
varying the pressure on the pedal.
The machine has three pre-set speed levels, to select them simply operate the switch (3) on the instrument
panel; the forward speed during operation depends on the amount of dirt to be removed and the type of
floor to be cleaned.
WARNING! The reverse speed is lower than the forward speed to comply
with current health and safety standards.
25.
MOVEMENT OF THE SIDE BRUSH
This machine is able to increase the working width by exploiting the right-hand side brush: just move the
joystick (1) on the instrument panel to the right. To move it back into its original place, move the joystick (1)
to the left.
26.
INCREASING THE PRESSURE ON THE BRUSH HEAD UNIT
This machine can increase the pressure on the brushes via the joystick (1) located on the instrument panel;
it has three different settings:
Step01: the weight exerted on the floor is 10kg;
Step02: the weight exerted on the floor is 45kg;
Step03: the weight exerted on the floor is 55kg.
WARNING! The pressure must be chosen according to the type of floor
and the amount of dirt. Increasing the pressure results in greater wear and
tear on the brushes and higher power consumption (for further
information, read “CHOOSING AND USING THE BRUSHES”).
4
2
1
1
1
3
