31
MACHINE PREPARATION
9.
Remove the right-hand carter (7) from the brush head unit, and place it on the ground
10.
Push the rear brush into the tunnel until it couples with the drive hub on the opposite side of the
tunnel
WARNING: Pay attention to the direction of the brush bristles during assembly,
the point of the brush viewed from the above should be towards the front of the
machine.
11.
Push the front brush into the tunnel until it couples with the drive hub on the opposite side of the
tunnel
WARNING: Make sure the brushes are correctly connected. If they are not, the
machine may not work properly.
WARNING: You are advised to always wear protective gloves, to avoid the risk
of serious injury to your hands.
37.
SIDE BRUSH ASSEMBLY
To assemble the side brush, proceed as follows:
1.
Check the side brush is in its standard (resting) position. If this is not the case, use the lever (1) on
the instrument panel to move it to the left
2.
Turn the main switch key anticlockwise to the "0" position
3.
Engage the parking brake located on the left side of the machine
4.
Remove the key from the instrument panel
WARNING: During this operation, verify that there are no people or objects near
the brush.
7
1
