36
WORK
For the battery version, as the batteries run out, the battery charge indicators on the command display will
go blank. When the batteries are fully discharged, the brush motor automatically switches off, so it is
necessary to recharge them as soon as possible.
A residual charge remains available to complete the drying process and to move the machine to the
charging point; to do this, choose the "Transfer" programme.
WARNING! The machine (version with combustion engine) is not fitted with an
LPG fuel reserve warning light.
If the LPG runs out while you are working, you can carry on with the aid of the gasoline fuel in the tank of
the combustion engine.
To select the fuel type, proceed as follows:
1.
Turn the main switch key (1) anticlockwise by a quarter of a turn (to position 0)
2.
Turn the 2-way fuel selection switch (2) to “GASOLINE”
3.
Turn the main switch key (1) clockwise by a quarter of a turn (to position 1). Bring the motor ignition
switch to the START position (turning the key further to the right), and keep it there until the motor
starts up; you can now release the key
WARNING! Only carry out this procedure with the machine switched off, and when
you are absolutely sure the LPG cylinder is completely empty (to replace the
cylinder, refer to “REPLACING THE LPG CYLINDER”).
WARNING! The machine (version with combustion engine) is not fitted with a
gasoline fuel reserve warning light, so keep an eye on the level of fuel in the
combustion engine tank.
To fill the fuel tank, refer to “FILLING THE FUEL TANK”.
When the level of solution (for versions without CDS) or water (for versions with CDS) is about to run out,
the red warning light (16) on the instrument panel will come on; when the solution or water is completely
used up, take the machine to the place designated for emptying the recovery tank. On completion of the
emptying operation, refill the solution tank.
16
1
2
