48
WEEKLY MAINTENANCE
9.
Remove the right-hand carter (7) from the brush head unit, and place it on the ground
10.
Take the rear brush out of the tunnel and rest it on the ground. Clean it with a jet of water
11.
Take the front brush out of the tunnel and rest it on the ground. Clean it with a jet of water
12.
Refit all the parts
57.
CLEANING THE SIDE BRUSH
Proceed as follows for cleaning:
1.
Check the side brush is in its idle position (if necessary, turn the I-DRIVE selector to the “Transfer”
position and push the lever (1) on the instrument panel)
2.
Check the electric system connector is disconnected from the battery connector (for battery versions)
or from the generator connector (for versions with a combustion engine)
3.
Make sure the main switch is in the "0" position. If it is not, turn the key a quarter turn to the left
4.
Check the parking brake is engaged. If it is not, engage it by means of the lever
5.
With the brush head up, release the brush from the brush-holder plate seat, and turn it anticlockwise
until the three studs slip out of the notches on the plate itself. Turn, so the stud is pushed away from
the coupling spring.
6.
Clean it under a jet of running water
7.
Refit all the parts
WARNING: You are advised to always wear protective gloves, to avoid the risk
of serious injury to your hands.
58.
ADJUSTING THE HEIGHT OF THE SIDE SPLASH GUARDS
If the side splash guard rubbers in the brush head unit are not well adjusted, they will not channel the
solution to the middle of the squeegee. To make the correct adjustment, proceed as follows:
1.
Make sure the brush head unit is in its working position (if necessary, turn the I-DRIVE selector to the
“Washing” position to lower the brush head)
2.
Check the electric system connector is disconnected from the battery connector (for battery versions)
or from the generator connector (for versions with a combustion engine)
3.
Make sure the main switch is in the "0" position. If it is not, turn the key a quarter turn to the left
4.
Check the parking brake is engaged. If it is not, engage it by means of the lever (1)
7
1
1
