55
EXTRAORDINARY MAINTENANCE
5.
Use a suitable tool to remove the rubber-pressing blade (2), loosening the screws (3) that fix it to the
splash guard support.
6.
Take the rubber (4) out, and turn or replace it
7.
To replace the rubber, proceed in reverse order
8.
Adjust the height of the splash guard rubber according to the rubber itself (refer to “ADJUSTING THE
HEIGHT OF THE SIDE SPLASH GUARDS”)
65.
REPLACING THE SPLASH GUARD RUBBER OF THE SIDE BRUSH
If the splash guard rubber of the side brush is worn and does not dry well, it is possible to change the
drying edge twice. To do this, proceed as follows:
1.
Make sure the brush head unit is in its working position (if necessary, turn the I-DRIVE selector to the
“Washing” position to lower the brush head)
2.
Place the side brush in its “Working” position by means of the relevant lever on the instrument panel
3.
Set the main switch to the "0" position by turning the key a quarter turn to the left.
4.
Check the electric system connector is disconnected from the battery connector (for battery versions)
or from the generator connector (for versions with a combustion engine)
5.
Check the parking brake is engaged. If it is not, engage it by means of the lever (1)
9.
Use a suitable tool to remove the rubber-pressing blade (2), loosening the screws (3) that fix it to the
side brush head
10.
Take the rubber (4) out, and turn or replace it
11.
To replace the rubber, proceed in reverse order
66.
REPLACING THE LPG CYLINDER (COMBUSTION ENGINE VERSION)
To replace the LPG cylinder when it is empty, proceed as follows:
1.
Engage the parking brake (1)
2.
Check the main machine switch (2) is in the “0” position. If this is not the case, turn the key by a
quarter rotation to the right.
3.
Unscrew the tube (4) from the tap (3), remembering to remove the seal between the two elements
3
2
4
1
1
2
3
4
3
4
2
