56
EXTRAORDINARY MAINTENANCE
4.
Fully close the cylinder tap (3)
5.
Remove the straps (5) by releasing the springs (6) from the screws (7) on the cylinder support, then
take off the cylinder
6.
Position the new cylinder as shown in the figure. If it is in the right place, the tap (3) will be on the left
side of the machine
7.
Fix the cylinder to its support by means of the straps (5). To do this, hook the spring (6) to the screw
(7) on the support
WARNING: Use only cylinders measuring 300x600 (max Ø x height in
millimetres) and weighing no more than 10kg.
8.
Tighten the tube (4) to the tap (3). Remember to insert the seal that's supplied with the cylinder
9.
Fully open the cylinder tap (3)
WARNING: The seal between the tap (3) and the tube (4) must be changed
every time the LPG cylinder is replaced.
WARNING: The LPG cylinder must not be replaced near flames, cinders or
active electric devices.
WARNING: Before replacing the LPG cylinder, make sure the taps (3) of both
the old cylinder and the new one are closed.
WARNING: The cylinder and tube (4) must never be exposed to heat sources.
67.
REPLACING THE STARTER BATTERY
The battery must be housed in the special compartment beneath the seat mounting plate. It should be
handled using lifting equipment that is suitable in terms of both weight and lifting method. It must also
meet the requisites of the following standards: CEI EN 50342, CEI EN 60095-2 and CEI EN 60095-4. The
dimensions of the battery compartment are: 229 mm x 132 mm x H165mm mm.
If you need to replace the starter battery, proceed as follows:
1.
Make sure the brush head unit is in its working position (if necessary, turn the I-DRIVE selector to the
“Transfer” position to raise both the brush head and the squeegee)
2.
Check the electric system connector is disconnected from the battery connector (for battery versions)
or from the generator connector (for versions with a combustion engine)
3.
Make sure the main switch is in the "0" position. If it is not, turn the key a quarter turn to the left
4.
Check the parking brake is engaged. If it is not, engage it by means of the lever (1)
3
5
7
6
3
4
5
6
3
4
2
1
